| Customization: | Available |
|---|---|
| Usage: | Environmental Protection |
| Style: | Tube |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Description of product
| Magnetic Separation Pulleys |
Installation Selections for Pulley Systems
SDM Magnetic Separation Pulleys could be installed in two basic configurations:
By applying a Magnetic Pulley alone which works fine in most installations.
Using the Magnetic Pulley in conjunction with a Magnetic Take-off Rail (pictured below) which helps convey the ferrous tramp back from the end of the conveyor and farther far from clean product stream. This works especially well for the smaller pulley diameters but is very effective on all sizes.
SDM Magnetics Co. Magnetic Separation Pulleys are even more effective when used in combination with overhead Magnetic Crossbelt Conveyors on thicker burdens or more dense conveyed materials.
This is usually done once the burden depths are high or when maximum separation is needed. It's because an overhead Magnetic Crossbelt might not purchase some nails or small steel plates lying directly on the belt surface with the use of a heavier burden like construction waste or in mining applications.
But when they get to the end of the conveyor - the bottom tramp metal is easily separated out with the magnetic separation head pulley.
A well-liked combination for maximum separation is a Ceramic Crossbelt with the use of and downstream from a Neo Rare Earth Magnetic Separation Pulley.
Medium Intensity Magnetic Grill having Gauss value of approximately 5,500 Gauss are used where the contamination is in particle form, however there may or may not be continuous movement of material to be separated. The contamination size may be as low as 150 microns but not lower than that. The material should be free flowing and non sticky.
High Intensity Magnetic Grill having Gauss value of approximately 10,000 Gauss are employed at locations where separation of contamination particles as small as 1 microns is required. These grills have been designed to attract super fine particles from the carrier material.
In all the three kinds of grill, it is a necessity to clean the grills at regular intervals. It is strongly recommended to clean the grill thoroughly before every pass (or as scheduled as per users requirement and knowledge). More accumulation of Iron particles for long time will decrease effectiveness of the grill. For highest attraction, the grill needs to be fully clean.
){kind=link}